Cata-Dyne™ Infrared Oven

Operation and Instructional Manual

This brief manual has been prepared to provide you with the general information required for the installation, operation, and maintenance of your Cata-Dyne™ INFRA-RED OVEN.

If there are any problems with the installation, start-up, or operation of your oven please feel free to contact:

CCI THERMAL TECHNOLOGIES INC.
5918 Roper Road
Edmonton, Alberta, Canada
T6B 3E1

Toll Free: 1-800-661-8529
Facsimile:  1-780-468-5904
www.ccithermal.com

For questions on the control panel contact:

TRINITY ELECTRONICS SYSTEMS LTD.
10708 – 181 Street
Edmonton, Alberta, Canada
T5S 1K8

Tel: 1-780-489-3199
Toll Free: 1-888-480-3199
Facsimile: 1-780-487-6397
E-mail: Tech Support

Safety

1. High voltage (120 VAC, 208 VAC, 220 VAC, 480 VAC, 600 VAC) is used in portions of the oven.  DO NOT perform wiring modifications to the oven or controls while the oven is running.

2. The oven controller is energized even if the oven is shut off. Consult the External Control Cabinet Wiring Diagram for specific details.  Disconnect all sources of power to the entire system at the breaker(s) before performing any modifications to the controller.  CCI Thermal Technologies Inc. must be notified before any modifications are made to the oven components.

3. Extreme caution should be used around the heater surfaces when the oven is operational.  The heater surfaces are extremely hot and can cause severe injury when touched.

4. Any damage to the heater surfaces must be repaired immediately.  Damage to the surface can result in un-reacted fuel passing through the heater potentially creating a fire or explosion hazard.  Return all damaged heaters to CCI Thermal Technologies Inc. for repair.

If you have any further questions, or for further assistance, please contact: